Instructions On Applying Vinyl

Vinyl decals can take an area from plain to original and fun within a few steps.

Instructions on applying vinyl.

Clean the area thoroughly with rubbing alcohol or soap and water. Step 1 clean the application area with alcohol or soap water. Place the decal on the car ensuring no part of the decal touches a try spot. Step 2 using a squeegee or credit card press firmly on the decal to ensure that the decal sticks to the application transfer paper.

Using a measuring tape measure the total distance of the surface the vinyl is to be applied to. Peel away the vinyl liner at a 45 degree angle. It s important to begin by cleaning the area. Take a look at our instructions guide below so your decal will adhere correctly.

This decal application instruction printable is the perfect item to add to your adhesive vinyl decal orders. Do not use a glass cleaner because it will leave a residue behind that will prevent the sticker from adhering well. Step 3 peel the paper backing away from the decal very slowly. While it is fairly simple it is important to follow some guidelines when you are applying.

Maneuver the decal into. Then take a heat gun or hairdryer and warm the surface and even some light heat on the sticker can t hurt don t put too much it can damage it. Peel the backing from the decal exposing the adhesive. Spray car generously with the application spray provided or use a mixture of soapy water in a spray bottle.

The top layer is paper transfer tape which is used to apply the decal. Divide the distance by 2 to determine the center point. Step 2 rub a squeegee or credit card firmly across the sticker through the clear transfer tape to prepare it for application. The bottom layer is the backing paper.

Do this a few times to tack up the surface plus it removes small pieces of dust and imperfections. Make sure your project surface is clean dry. It is simple to the point and will clearly direct your buyer on how to correctly and successfully apply a vinyl decal. Begin by ensuring the surface has been cleaned and prepared properly.

When you receive your decal in the mail lay it flat and firmly wipe a credit card or application squeegee across the top of the transfer tape. The second layer is the vinyl film which is the decal itself. Carefully place the transfer tape with vinyl images onto your surface as you would like them to appear. Apply masking tape on the area then remove.

Mark this location on the surface using your grease pencil. Step 4 apply decal to cleaned area pressing firmly using squeegee or credit card.