Installing Handles On Cabinet Doors

Anywhere within this range will work as it is based on personal preference.

Installing handles on cabinet doors.

Install the knobs and pulls the knob hardware itself is held in place on the front of the door while the screws are inserted into the hole in the door from the back. We needed to determine the length that we wanted them to be based on the thickness of our specific cabinet doors. This creates a crosshair with horizontal line. Install it so all the knobs on the cabinet are spaced evenly.

This kit includes door and drawer templates as well as a 3 16 in. Install new cabinet handles insert the fastening screw s through the backside of the hole. Drill bit accommodating larger pulls up to 160 mm. More product details close.

Simply mark drill and then attach new cabinet hardware. You ll specifically want to place them anywhere between 1 and 4 from the top or bottom edge of the door. When it comes to installing cabinet door handles either knobs or pulls they are always placed on the opposite side from the door hinges. While holding the knob or handle with one hand use a screwdriver to tighten the fastening screw.

Use a tape measure to find center of the cabinet door frame and mark with pencil. Cabinet hardware jig adjustable punch locator tool drill guide template wood drilling doweling for installation of handles knobs on doors and drawer pull with storage bag 4 2 out of 5 stars 385 17 99 17. Our specific knobs came with snap off screws. Install hardware higher on the lowest drawer most drawer pulls are centered on the drawer fronts but if the cabinet you re working on has two or three drawers the same size and one larger one at the bottom install the bottom knob or pull higher than the center of that drawer front.

Thread the knob or handle onto the screw s. Slip the template over the edge of the door or drawer front position it where you want it and drill the hole. The ideal template for installing door handles and drawer pulls is made from two pieces of 1 4 inch plywood attached to a wooden core to form a u shape. The hubs used two sets of pliers to wiggle and snap the screws off at the correct point for the cabinet pulls we used the same kind of method.