Learning how to run the cable from basement to the second floor once you are all set simply shut the power off from the main board and get started.
Inexpensive way to run ethernet to basement from second floor.
Mount a low voltage plate to the wall and then fish the fire up to it finish it with a wall plate.
Wherever you want to put the outlet drill a small hole.
Purchase here best price.
The ethernet cable will pass through the top floor into the basement at the closest point to the location of the device on the lower level.
On an interior wall you can cut the opening for the wall plate on the 2nd floor then use a flex bit to drill down into the cavity of the wall on the first floor.
But can be done.
Running through interior closet walls for all three.
Spot an access point in the middle of the floors.
The really really cheapest way is to run your ethernet cable along the floor and through the doorways.
Find a good place to run the wire from the basement to the attic.
The two wiring standards for ethernet cable termination are t568a and t568b.
You can also drill two holes in the floor and run the cable through the basement.
Sometimes i was able to use existing holes from phone wiring.
One will run next to a heat duct that goes up to the second floor.
The second cheapest way is to drill a hole in the floor of each room near a convenient wall and pull a cable through basement or crawl space.
Then drill up from the basement into that same wall cavity and use fish tape to get all the way up.
Punch a hole from the basement assuming you have one into the wall where the router is.
Might take some work to get up there.
The bigger the hole the better.
Other places i had to drill.
What i personally have done is just run the wire myself but it s a lot of work.
Use the coat hanger to see if everything is fine at this location and there are no obstructions.
Best way to run cable from basement to second floor need to run some cables coax power cat6 from the basement to the second floor attic bungalow in 3 different places.